Värme, Luftvård

Oscillating table fan with front grille.

Mobile diesel heating fan for efficient drying of construction sites or heating of well-ventilated spaces. Stainless steel combustion chamber. With flame sensor, overheating protection and regulation equipment. Equipped with a chimney to be able to lead the exhaust gases away and out. Electrical connection 230 V. Supplied with 1.6 m connection cable. Protection class IPX4.
NOTE! Ensure good ventilation before use.

Mobile diesel heating fan for efficient drying of construction sites or heating of well-ventilated spaces. Stainless steel combustion chamber. With flame sensor, overheating protection and regulation equipment. Equipped with a chimney to be able to lead the exhaust gases away and out. Electrical connection 230 V. Supplied with 1.6 m connection cable. Protection class IPX4.
NOTE! Ensure good ventilation before use.

Mobile diesel heating fan for efficient drying of construction sites or heating of well-ventilated spaces. Stainless steel combustion chamber. With flame sensor, overheating protection and regulation equipment. Equipped with a chimney to be able to lead the exhaust gases away and out. Electrical connection 230 V. Supplied with 1.6 m connection cable. Protection class IPX4.
NOTE! Ensure good ventilation before use.

Frost guard for use in dry and damp areas, e.g. pump houses, water meters, garages, storage rooms, caravans, boats, greenhouses and food cellars. Modular house made of white lacquered sheet steel with integrated wall brackets. Equipped with a bimetal thermostat, this means that you can try to find the optimal position adapted to the space you wish to heat. When the thermostat is set to the desired position, for example 1 or 2 etc, it works according to the desired setting, ± 2°C depending on the ambient temperature. Use a thermometer to check that the room is at the correct temperature. Supplied with 1 m cable with grounded plug.
Voltage: 230 V-50 Hz.
Power: 200 W.
Control range: +5°C to +35°C.
Protection class: IP21.
Dimensions (HxWxD): 365x120x75 mm.

Portable gas heater with electronic ignition. Powered by propane gas and equipped with overheating protection and tipping protection. Nozzle with strong oxygen supply makes combustion complete. Suitable for construction sites, workshop/farm buildings, sporting events, barns and factories. Supplied with hose and adapter.

Portable gas heater with electronic ignition. Powered by propane gas and equipped with overheating protection and tipping protection. Nozzle with strong oxygen supply makes combustion complete. Suitable for construction sites, workshop/farm buildings, sporting events, barns and factories. Supplied with hose and adapter.

Portable gas heater with electronic ignition. Powered by propane gas and equipped with overheating protection and tipping protection. Nozzle with strong oxygen supply makes combustion complete. Suitable for construction sites, workshop/farm buildings, sporting events, barns and factories. Supplied with hose and adapter.

Oscillating. Adjustable height 140-165 cm.

Convector element for extra heating indoors. Equipped with stepless thermostat, overheating protection and carrying handles on the sides. Three power modes 750 W / 1250 W / 2000 W. 230 V. Max capacity 20 m². Weight 3.7 kg.

Interior heater with low noise level. 360° swivel mount with bayonet connection. Floor stand, wall bracket and Quick clip included. On/Off button + effect. Can be mounted upside down. Temperature controlled output (PTC) 1100/1700W at -25°C. Automatic overheating protection (resettable). Standard 230V plug.
Nom. power: 1100/1700 W
Voltage: 230 V
Weight: 0.9 kg
Contact version ID: Schuko

Fully automatic dehumidifier with built-in hygrostat. The water is collected in the built-in water tank of 5.5 litres, with level monitor. A light indicates when it is time to empty the container. Hose for direct emptying can be installed.

Effective dehumidification of new construction, drying after water damage or to keep the humidity down in warehouses. Easy to handle. Large wheels and strong handle for easy movement on uneven surfaces. Easy to install - connects with a 230 volt plug. Condensate tank with overflow control. Tank volume 9 liters. Equipped with hour meter. Drain hose can be connected for constant emptying 3/4" external thread. Robust construction for professional use. Working temperature 0-35 degrees C.

Air purifier that provides clean air at the workplace, in dust class M. Usable on the construction site and in the workshop, for work where it is difficult or impossible to use extraction, for demolition and renovation, etc. Small and light in compact Systainer format with carrying handle, allows it is perfectly suited for mobile use. Filters out harmful dust that hangs in the air despite the use of vacuum cleaners. Effective two-stage filter system that cleans the air thoroughly. Even the smallest dust particles and other harmful substances are filtered out. Dust class M, for health-hazardous dust in dust class M with limit values ??> 0.1 mg/m³, filtration rate > 99.9%. Pre-filter protects the main filter by filtering out most of the dust. Main filter in TripleV form with extra large filter surface that does not clog as quickly and lasts longer. Air circulation of up to 680 m³/h, changes the air up to 3 times/h in a 57 m² room. The volume flow can be set in two steps depending on how much dust is generated. The air stream spreads upwards in three directions (left, right, back). Signal light warns of clogged filters and shows when it is time to change the filter. With power outlet, for connecting more SYS-AIR air purifiers or power tools. Up to six air cleaners can be connected in series, thus increasing the ventilation speed and improving air quality. Connection point for supply air hose Ø 200 mm (accessory), for hard-to-reach spaces or dust protection walls. The air purifier can be connected to Systainr and vacuum cleaners with T-LOC or to the SYS-RB trolley for easy transport. Safe storage of the mains cable in the lid.
Standard equipment: Pre-filter VF-SYS-AIR and main filter HF-SYS-AIR M.

Heating fan for extra heating of premises. Equipped with stepless thermostat, overheating protection and carrying handle. Two power modes 1000 W / 2000 W. 1-phase, 230 V. Max capacity 20 m². Protection class IP24.

Heating fan for extra heating of premises. Equipped with stepless thermostat, overheating protection and carrying handle. Three power modes 40 W / 1650 W / 3300 W. 1-phase, 230 V. Max capacity 30 m². Weight 5.9 kg. Protection class IP24.

Heating fan for extra heating of premises. Equipped with stepless thermostat, overheating protection and carrying handle. Three power modes 55 W / 2500 W / 5000 W. 3-phase, 400 V. Max capacity 48 m². Weight 7.2 kg. Protection class IP24.

Heating fan for extra heating of premises. Equipped with stepless thermostat, overheating protection and carrying handle. Three power modes 55 W / 4500 W / 9000 W. 3-phase, 400 V. Max capacity 80 m². Weight 10.2 kg. Protection class IP24.

Robust and reliable fan heater. Equipped with thermal fuse. Made of sheet steel and painted with heat-resistant paint. Strong carrying handle. Three effect stages. Fixed 16A CEE socket. 400 V.
Approved for outdoor use. IP44.
Air flow: 708 m³/h.
Weight: 9.4 kg.

Fan heater 230 V. Developed to withstand environments on construction sites, industries and public places. Round construction enables high energy efficiency and fast heating/drying. Display with built-in electronic thermostat that provides more even heat, lower energy consumption, and easy setting. Three power modes. Aimable. Integrated cable winder. Insulated lifting handle. Stackable for storage. Overheat protection. 1.8 m cable (3G1.5 mm²) with plug.
Approved for outdoor use. IP44.
Air flow: 450 m³/h.
Weight: 4.8 kg.

Heater fan 400 V. Developed to withstand environments on construction sites, industries and public places. Round construction enables high energy efficiency and fast heating/drying. Display with built-in electronic thermostat that provides more even heat, lower energy consumption, and easy setting. Three power modes. Aimable. Integrated cable winder. Insulated lifting handle. Stackable for storage. Overheat protection. 1.8 m cable (5G2.5 mm²) with plug.
Approved for outdoor use. IP44.
Air flow: 450 m³/h.
Weight: 8.1 kg.

Heating fan for heating premises. Thermostat with two power settings. Overheating protection with thermal fuse. Rubber connection cord. Strong carrying handle. 230 V, 1-phase.
Approved for outdoor use. IP44.
Airflow: 300 m³/h.
Weight: 5 kg.

Heating fan for heating premises. With thermostat and four power settings, fan only, 1/3, 2/3 and full power. Equipped with overheating protection with thermal fuse. After use, the knob should be set to fan only to cool down the elements. If the fan is switched off without cooling, the fuse may trip. Strong carrying handle. 1.5 m connection cable with 16A CEE don. 400 V.
Approved for outdoor use. IP44.
Airflow: 1300 m³/h.
Weight: 10 kg.

Robust and reliable fan heater 230 V, equipped with thermal fuse. Made of sheet steel and painted with heat-resistant paint.
Approved for outdoor use. IP44.
Power level: 25/1000/2000 W.
Air flow: 186 m³/h.
Noise level: 51 dB.
Weight: 3.5 kg.
Supplied complete with cord and plug.

Robust and reliable fan heater 400 V, equipped with thermal fuse. Made of sheet steel and painted with heat-resistant paint. Electrical connection intake type 416.
Approved for outdoor use. IP44.
Power level: 30/2500/5000 W.
Air flow: 530 m³/h.
Noise level: 54 dB.
Weight: 5.6 kg.
Supplied without cord and plug.

Standing fan heater with heating mode 1000 or 2000 W and fresh air mode. Manual adjustable thermostat. Overheating protection and tipping protection. Cord length 1.5 m.
Approved for wet areas. IP21.
Weight: 1.2 kg.